Loss of control
Japan
Published 13 Jun 2022
Ref JP-1234250
Scania: Other (Engine)
Translated from Japanese · machine translation
- Country
- Japan
- Published
- 13 Jun 2022
- Units affected
- 6
- Reference
- JP-1234250
Affected vehicles
スカニア ECP37ZX 2020
スカニア ECP43CX 2020
スカニア ECP47CX 2020
Hazard
Improper mounting position of cab auxiliary heater wiring causes interference and rubbing against the cab auxiliary heater bracket. In the worst case, wiring damage may prevent the cab auxiliary heater from operating or cause short circuits. Additionally, adverse effects on the cab auxiliary heater signal can negatively impact fuel supply pump control signals, causing the fuel supply pump to continue operating even when the ignition key is turned off. This allows the engine to continue running until fuel is depleted, potentially resulting in engine stall.
Show original (日本語)
キャブ補助ヒーターの配線の取付位置が不適切なため、キャブ補助ヒーターブラケットと干渉し擦れるものがある。このため、最悪の場合、配線の損傷によりキャブ補助ヒーターが作動しなくなったり、ショートが発生したりする。またキャブ補助ヒーターの信号に悪影響を及ぼすことで、燃料供給ポンプの制御信号に悪影響を与え、イグニッションキーをオフにしても燃料供給ポンプが停止せずエンジンがまわりつづけ燃料が切れることでエンストに至る恐れがある。
Remedy
For all vehicles, inspect damage conditions and secure the wiring to the heater hose to prevent interference. If inspection reveals only minor surface abrasion, protect with tape. If the insulation is damaged and copper wire is exposed, replace the harness.
Show original (日本語)
全車両、損傷状況を確認し、配線が干渉しないようヒーターホースに固定する。なお、損傷状況を確認の結果、表面的な軽度な擦れの場合はテープにより保護する。また被覆がはがれ銅線が露出している場合はハーネスを交換する。