Loss of control
Japan
Published 13 Jun 2022
Ref JP-1234290
Scania: Other (Engine)
Translated from Japanese · machine translation
- Country
- Japan
- Published
- 13 Jun 2022
- Units affected
- 14
- Reference
- JP-1234290
Affected vehicles
スカニア BSF2110 Concrete Work Vehicle 2020–2021
スカニア BSF28-4.16H Concrete Work Vehicle 2020–2021
スカニア BSF38-5.16H 2020–2021
スカニア BSF46-5.16H 2020–2021
Hazard
The cab auxiliary heater wiring is mounted at an improper position, causing interference and abrasion with the cab auxiliary heater bracket. In the worst case, wiring damage may cause the cab auxiliary heater to malfunction or short circuit. Additionally, adverse effects on the cab auxiliary heater signal may negatively impact the fuel supply pump control signal, causing the fuel supply pump to remain operational even when the ignition key is turned off, resulting in engine stalling when fuel is depleted.
Show original (日本語)
キャブ補助ヒーターの配線の取付位置が不適切なため、キャブ補助ヒーターブラケットと干渉し擦れるものがある。このため、最悪の場合、配線の損傷によりキャブ補助ヒーターが作動しなくなったり、ショートが発生したりする。またキャブ補助ヒーターの信号に悪影響を及ぼすことで、燃料供給ポンプの制御信号に悪影響を与え、イグニッションキーをオフにしても燃料供給ポンプが停止せずエンジンがまわりつづけ燃料が切れることでエンストに至る恐れがある。
Remedy
For all vehicles, inspect the wiring condition and secure the wiring to the heater hose to prevent interference. If inspection reveals only minor surface abrasion, protect with tape. If the insulation is damaged and copper wire is exposed, replace the wiring harness.
Show original (日本語)
全車両、損傷状況を確認し、配線が干渉しないようヒーターホースに固定する。なお、損傷状況を確認の結果、表面的な軽度な擦れの場合はテープにより保護する。また被覆がはがれ銅線が露出している場合はハーネスを交換する。